10 uF Feed Through Capacitor for MIL-STD and DO-160
The ruggedly constructed feed-thru capacitors are highly reliable units for general use in screen rooms and other environments. It has four threaded inserts for easy installation on metal enclosure. Its M6 threaded feed-thru stud will allow power current of 100 Amps without heating or voltage loss. These have low dissipation factors, high temperature ratings, high insulation resistance, doubly rated dielectric strength, and long life. A bleeder resistor is included within the capacitors, to discharge the capacitors when applied voltage is removed.
- Built-in discharge resistor for safety
- Excellent stability with long life
- High insulation resistance
- Allows bulkhead or bench mounting
- Capacitance: 10 µF ±10%
- Current: 100 Amp at 40 degrees C
- Voltage: 275 VAC RMS (60 Hz), 250 VAC RMS (400Hz), 600 VDC
- Temperature: -55°C to +70°C @ rated voltage +105°C @ 50% of rated voltage
- Dissipation factor: Less than 1% at 25°C (measured at 120 Hz)
- Dielectric strength: Twice the rated VDC @ 25°C for two minutes
- Bleeder Insulation resistance: 1.5 MΩ + 5 % @ 25°C rated voltage.
- Insulation Resistance: 100MΩ prior to adding bleeder resistance
- Construction: Brass, Nickel Plated
Quote Request
Other EMC Test Equipment
- Absorbing Clamps
- Antenna Kits
- Antenna Masts - Automated and Manual
- Antennas
- CDNs - Coupling Decoupling Network
- Comb Generators
- Current & BCI Probes, Calibration Fixtures
- Discontinued Products
- EM Clamps
- Feed Through Capacitor
- Immunity Systems
- ISNs - Impedance Stabilization Network
- Line Impedance Stabilization Network LISNs
- Magnetic Field Generator
- Near Field Probes
- Power Amplifiers
- Pre-compliance Emissions Test Systems
- Preamplifiers
- Spectrum Analyzers
- Surge Generators
- System Controllers
- Telecom Analyzer
- Telecom Test System
- Transient Limiters
- Tripods For EMC
- Turntables